I have an old flat screen LG TV
Using RPi2, the TV remote doesn't seems to have any LibreElec Operation 
Any help ? Any Clue ? 
thanks
LG TV Remote
-
stekam69 -
August 12, 2016 at 12:36 PM -
Thread is Unresolved
-
-
Does the TV have CEC enabled?
Think it's called simplink on LG. -
Does the TV have CEC enabled?
Think it's called simplink on LG.Oooooh ! so maybe in the LG settings...
I'm not home now, but In case it is... You think about anything else ?
-
Oooooh ! so maybe in the LG settings...
I'm not home now, but In case it is... You think about anything else ?
I believe with some tv's it works only on one hdmi connection. Try different HDMI connector if possible.
-
I believe with some tv's it works only on one hdmi connection. Try different HDMI connector if possible.
Hmmmm ! that might be something too ! I have an HDMI encoder/TV on one of the ports...
i'll try that
-
- Official Post
Depends on the LG TV. My 2012 LG TV has CEC on all ports.
-
Mine only has it on 1 of the two HDMI ports, although they are labelled differently as well.
I fairly often have to re-enable it if I switch sources and then go back to HDMI 2 where the Pi is connected. The Pi appears as "HDD Recorder" (or something like that) under the Simplink menu, in my TV via the green button from the sources menu.
-
yep, my LG is also little bit picky.. Doesnt run simplink automatically, and often I must manualy set up for HDD recorder. TV says "Simplink doesnt work" or something like that, but after few seconds it works. So, if you dont have AVR between Pi and TV, and your LG knows CEC (Simplink), you should be good after all (standard setting, righ HDMI port, enabled CEC in LibreElec and enabling CEC on TV)
