Problems with HDMI

Hi! I have a problem. I've update my libreelect from LibreELEC 9.2.8 to 11.0.3. I have a raspberry pi 4 model B.

When I turn on the raspberry pi after 5 seconds the TV said. No HDMI connected.

I have read in this forum that if you try to connect by ssh and you put the command getedid create would be fixed, but for me its impossible configure the raspberry pi with ssh because its off by default and I can not watch anything in the tv because the tv can not detect the HDMI.

If I put again the old version 9.2.9 of LibreELEC I dont have any problem. But I would like update LibreElec

any solutions?? Thanks!

Hello, I tried to do that but it was impossible.

What am I doing bad?

Quote from VLouis

Hi, That command is useful in the case when sometimes the RPi (LE - at startup) doesn't detect the display (ex. some displays in stand-by mode doesn't provide EDID information trough HDMI). You are sure don't have any hardware issue? Try with another HDMI cable, another HDMI output/input, another display... I'm using RPi4B with LE too, and I don't have HDMI/Display problem (I have set a cronjob for LE to reboot it every night and I used that getedid command to ensure the display is "detected" even if in StBy).

Yes I have tried other TV, another HDMI cable. But the problem its with Libreelect 9 its work fine but with 10 or 11 no...

Quote from Boronsbruder

Wrong directory i think...
If I connect the SD-card to my Destop PC it shows up a partition called LIBREELEC looking like this

There should the ssh and the userconf.txt files go.

And you have to encrypt the password with openssl

Code

 openssl passwd -6

1) I already have ssh file and userconf.txt inside the LIBREELECT

2) I edited userconf.txt with root:libreelec (cipher with openssl)

3) I made a Nmap Scan and can see my Libreelec

4) Now ssh root@192.168.1.106 ... and I get a conection refused

5) I try in windows with putty and I get a conection timed out

Quote from Da Flex

Try a better PSU.

I have tried as well.

It's strange because with Libreelec version 9 I don't have problems only with 10 and 11

I have put ssh to the end of cmdline.txt but doesnt work.

I dont have a PC monitor here to try. Just 2 tv Samsung but any of them I can watch LE

I dont know what I can do more.

Quote from frakkin64

Works fine with my Samsung TV, no tweaks necessary really (mine is 4K, so mainly just have 4kp60 enabled in config.txt).

What model Samsung?
Is it 4K?
Are you plugging into the right HDMI port (one near the power input)?
Are you using ethernet or wireless?

The model its UE49J5200AWXXC

Its no 4k

Yes I have tried pluggin in both connectors HDMI of my PI

Im using ethernet

I found the problem. It was the adapter and didn't work very well. I have bought a new one finally.

Thanks for everything guys!