FSCK errors with LE 8.09.006

VoSed · November 10, 2018 at 11:58 AM

I ran into a problem on RPi3. When, after using LE, I check the file system of the sdcard, fsck reports errors. Free blocks and inodes counts wrong. After fixing, these errors disappear. But reappear after launching LE. My sdcard is SanDisk Ultra 16GB. Surface test passed.

**Iridium** · November 10, 2018 at 5:26 PM Official Post

Sounds like the card has become faulty. Please provide full logs and the output of

dmesg | paste and

journalctl | paste

Please provide a full debug log.

How to post a log (wiki)

1. Enable debugging in Settings>System Settings>Logging
2. Restart Kodi
3. Replicate the problem
4. Generate a log URL (do not post/upload logs to the forum)

use "Settings > LibreELEC > System > Paste system logs" or run "pastekodi" over SSH, then post the URL link

VoSed · November 11, 2018 at 9:54 AM

I did fresh install and setup on same reformated (flash erase) card. After setup, I turned off my RPi3 and checked the card for errors. Free blocks and inodes count wrong. fsck fixed that. I did turn on RPi3 for change dvb driver. After reboot I checked fsck again. Only Recovering journal Messege. Card is ok

dmesg http://ix.io/1ry7

**chewitt** · November 11, 2018 at 1:13 PM Official Post

Frequent corruption issues are often the result of an inadequate PSU .. the other cause being a card that's on its way out.

VoSed · November 11, 2018 at 2:21 PM

Why LE doesn't react to these errors during startup (doesn't start fsck)?

LE23 · November 15, 2018 at 1:02 PM

That would be too user friendly.

**vpeter** · November 15, 2018 at 1:04 PM

Quote from VoSed

Why LE doesn't react to these errors during startup (doesn't start fsck)?

Last time I checked fsck was run every time on boot. Not sure why in your case doesn't detect and fix errors.