I can't seem to be able to set my IP address manually on LibreELEC (Krypton) v7.90.002 ALPHA. There is no visible "save" button and this by the way is on a fresh install.
Shedrock
Can't set manual IP address
-
shedrock -
July 8, 2016 at 11:36 PM -
Thread is Unresolved
-
- Official Post
Sounds like possibly a skin issue, are you using estuary? Maybe skinning for le settings is incomplete. Try confluence and then you can switch back.
-
- Official Post
It's been fixed, just wait for 7.90.003
-
Alternatively you can probably set a static IP via your router's DHCP settings. I prefer that method myself, as works for all devices and it's persistent if and when I change os or re-install.
-
- Official Post
Confirmed that it works in 7.90.003
You may need to update LE as there is not yet an image (Only 7.90.002) so use LE Config in Kodi.
-
It's been fixed, just wait for 7.90.003I still can't get my amp to switch over to DTS.
-
I still can't get my amp to switch over to DTS.
How is this related to the IP address?
-
So where is the new thread with the log files? Or at least some more details, like how the amp is connected?
-
- Official Post
yes...without them it's only guessing. And I would recommend to start a new thread. Users who might be able to answer this probably won't look at a thread which is IP related
-
- Official Post
Did you enabled any specific logging? The logfile is way to long for just booting, playing a dts file and grabbing the log.
Could you also please show some screenshots of your audio settings
-
- Official Post
none...I was only wondering because of the log being that long...
If I take a look at this at Line 201 in your log, which seems to open a video stream and then take a look at line 216:
14:38:07 39.683319 T:139990796261120 NOTICE: Creating audio stream (codec id: 86020, channels: 6, sample rate: 48000, no pass-through)
There don't seem to be any passthrough.
So if you are sure you have passthrough activated, are you sure you have "sync playback to display" deactivated. As this will deactivate passthrough
In the explaination of that setting, it's said:
"Synchronise video and audio to the refresh rate of the monitor. VideoPlayer won't use passthrough audio in this case because resampling may be required."
And if I saw it correctly, you have VDPAU and VAAPI enabled. You only need one of them. In your case, as you use Intel GPU, you don't need VDPAU. VDPAU is for NVidia and VAAPI is for intel.
But get us the screenshots. They will tell most, I guess. I'm not the biggest guru in understanding any part of those logs
