Could somebody tell or explain how we could watch 4k content in 10 bit hdr with libreelec 10.0.0?
Libreelec 10.0.0 rpi4 hdr 4k 10 bit
-
harun-cuk17 -
September 16, 2021 at 4:09 PM -
Thread is Unresolved
-
- Official Post
You wait patiently until 10/12-bit support has been added. Until then you can watch 10-bit content downsampled to 8-bit output, which works fine with the 10.0.0 release.
-
You wait patiently until 10/12-bit support has been added. Until then you can watch 10-bit content downsampled to 8-bit output, which works fine with the 10.0.0 release.
Thanks buddy. When I open 10 bit movie some time the screen is going on no signal. What do I need to change in settings to solve this issue?
-
- Official Post
Standard problems are poor quality HDMI cables and inadequate PSU.
-
- Official Post
You shouldn't have to whitelist resolutions unless you want to.
Please post a kodi debug log after trying to play said media.
-
- Official Post
What about that debug log? We don't have a crystal ball in our midst.
-
- Official Post
Is the problem maybe because my kodi UI is set to 1920x1080 120hz
In that case yes you will have to use the whitelist
-
What about that debug log? We don't have a crystal ball in our midst.
Well could you tell me to how to make the debug log please?
In that case yes you will have to use the whitelist
Which resolutions do I need to whitelist?
-
- Official Post
Well could you tell me to how to make the debug log please?
Which resolutions do I need to whitelist?
The 4K resolutions I would imagine (plus any others that you think you may need, 1080P, etc).
-
- Official Post
Well could you tell me to how to make the debug log please?
Sure...
Please provide a full debug log.How to post a log (wiki)1. Enable debugging in Settings>System Settings>Logging2. Restart Kodi3. Replicate the problem4. Generate a log URL (do not post/upload logs to the forum)
use "Settings > LibreELEC > System > Paste system logs" or run "pastekodi" over SSH, then post the URL link -
Standard problems are poor quality HDMI cables and inadequate PSU.
Inadequate PSU, does that include the official one for rpi3? I've noticed some weird things happening when an external hard drive is connected. Sometimes the screen turns blank for a couple seconds and the USB remote becomes less responsive. These problems seem to disappear as soon as the USB drive is disconnected.
-
- Official Post
The official RPi3 PSU (presumably with a USB-C adaptor) is under-spec for an RPi4.
