Okay been following this thread and have some questions which I hope I can get some good answers here from you guys.
Firstly. I have just got new Tanix TX9 Pro 3/32GB S912 box with its imnpressive specs, higher price but still good value. I see no mention of this box searching through the threads here only for the Tanix TX92 with what seems to be the same specifications except a more ventilated case with a power button. So what if any is the difference as they are both the same specs from all I can see and even some say they both have 3G DDR4 and others say one or the other or both have 3G DDR3, so that is the only vague differences I can see.
Secondly. Okay I can say that the TX9 Pro works extemly well with the S912 LE 188.8.131.52 firmware with no freezes and no obvious problems. In fact it runs very well and seems faster than my TX7 S905X 2/32GB box. Both by the way are running LE 184.108.40.206 off of the same type fast Class 10 SD cards and I have one similarly running 220.127.116.11 on another S905X Beelink box. However, and no matter what 1Gb Ethernet port device tree I use (and many wont work) my Gigabit LAN switch indicators never shows a 1Gb connection only the usual standard 100GB. Same even with the newer 18.104.22.168 LE firmware on the TX9 Pro. Can anyone explain why this is ?? For my LAN with my fast NAS drive the Gigabit LAN port on this box would be good for watching stored 4K movies, and some with HDR too, streamed over my Gigabit LAN as I believe I need at least 120 Mbps and ideally a little more with HDR and 5.1 audio too.
Thirdly. I have tried and have sort of got working the newer LE 22.214.171.124 firmware on the TX9 Pro box on separate same type SD card after trying several appropriate device trees, but found the same one I use for the 126.96.36.199 build supporting the TX9 with the 1Gb Lan works best . However i am suffering from freezes that do seem to be heat related, even though I have NOT enabled the GPU overclocking feature. I think this is heat simply because the box runs fine for the first 20 minutes or so and then freezes reuiring a hard power off reboot, and keeps freezing almost immediately after each new reboot too. Strangely although the temperature is showing around 70C ( I live in a very hot Thailand) this is exactly the same temperature I see when using the 188.8.131.52 build wiht this same box, and which does not freeze at all ?? Any advice on this appreicated.
Latly. I cannot get the newer LibreELEC-S912.arm-8.2.4-Oclock-GPU.img.gz build working at all despite trying many 3G with IGb lan device trees. All as I say running a dual boot system with the fast 16GB SD card used for LE.
Thanks in advance for any help with these queries.