Tanix tx6 no wifi & bt drivers

atari · May 6, 2023 at 10:44 AM

On image 11.0.1 wifi drivers not working

Can i add it tru ssh?

**heitbaum** · May 6, 2023 at 12:40 PM

Can you please confirm the model number on the bottom.

As I believe this is not a model I have/have tested. Mine both use the rtw88 driver.

Code

[    5.943731] brcmfmac: brcmf_fw_alloc_request: using brcm/brcmfmac4330-sdio for chip BCM4330/4
[    5.943879] brcmfmac mmc1:0001:1: Direct firmware load for brcm/brcmfmac4330-sdio.oranth,tanix-tx6.bin failed with error -2
[    5.944689] usbcore: registered new interface driver brcmfmac

**heitbaum** · May 6, 2023 at 12:55 PM

You can check if this changes/fixes the wireless with the bcm4330

Code

mkdir -p /storage/.config/firmware/brcm
cd /storage/.config/firmware/brcm
ln -s /lib/firmware/brcm/brcmfmac4330-sdio.bin brcmfmac4330-sdio.oranth,tanix-tx6.bin
ln -s /lib/firmware/brcm/brcmfmac4330-sdio.txt brcmfmac4330-sdio.oranth,tanix-tx6.txt

reboot

**chewitt** · May 7, 2023 at 2:58 PM

The "error" messages related to brcmfmac are harmless since the driver falls back to the generic filenames automatically and no device has the clm_blob file available (and it's not essential. All looks good to me; so there should be a wlan0 device in the OS and you should be able to configure a WiFi connection. If not, share "journalctl | paste" after attempting to configure a connection.

atari · May 7, 2023 at 10:09 PM

device is not in list 20190329.L4

CS_H6_TX28_DTX_V1.0

atari · May 8, 2023 at 1:04 AM

I add dir & link but still no wifi&bt

http://ix.io/4vqG

**chewitt** · May 8, 2023 at 7:48 AM

Code

mkdir -p /storage/.config/firmware/brcm
wget http://ix.io/4tpc -O /storage/.config/firmware/brcm/brcmfmac4330-sdio.oranth,tanix-tx6.txt
reboot

^ see if that nvram config works better. Run "pastekodi" and "ifconfig | paste" after boot and share the URLs. Also ensure the correct wireless regulatory domain has been configured in LE settings.

atari · May 8, 2023 at 9:19 AM

wget: can't open '/storage/.config/firmware/brcm/brcmfmac4330-sdio.oranth,tanix- tx6.txt': Read-only file system

http://ix.io/4vrC

**heitbaum** · May 8, 2023 at 10:14 AM

Do this first the link is pointing wget to the read only disk.

rm /storage/.config/firmware/brcm/brcmfmac4330-sdio.oranth,tanix-tx6.txt

**heitbaum** · May 8, 2023 at 10:20 AM

I can see your wlan0 device.

Can you try to see what ssid you can see.

iw dev wlan0 scan

atari · May 8, 2023 at 4:22 PM

Thanks, now wifi works but only 2.4, 5ghz&bt not

iw dev wlan0 scan

BSS b8:69:f4:d9:6b:36(on wlan0)

last seen: 42.585s [boottime]

TSF: 0 usec (0d, 00:00:00)

freq: 2412

beacon interval: 100 TUs

capability: ESS Privacy ShortPreamble ShortSlotTime (0x0431)

signal: -34.00 dBm

last seen: 104 ms ago

SSID: neutrino-digital.com

Supported rates: 1.0* 2.0* 5.5* 11.0* 6.0 9.0 12.0 18.0

DS Parameter set: channel 1

ERP: <no flags>

HT capabilities:

Capabilities: 0x102c

HT20

SM Power Save disabled

RX HT20 SGI

No RX STBC

Max AMSDU length: 3839 bytes

DSSS/CCK HT40

Maximum RX AMPDU length 65535 bytes (exponent: 0x003)

Minimum RX AMPDU time spacing: No restriction (0x00)

HT RX MCS rate indexes supported: 0-15

HT TX MCS rate indexes are undefined

RSN: * Version: 1

* Group cipher: CCMP

* Pairwise ciphers: CCMP

* Authentication suites: PSK

* Capabilities: 1-PTKSA-RC 1-GTKSA-RC (0x0000)

Extended supported rates: 24.0 36.0 48.0 54.0

HT operation:

* primary channel: 1

* secondary channel offset: no secondary

* STA channel width: 20 MHz

* RIFS: 0

* HT protection: no

* non-GF present: 0

* OBSS non-GF present: 0

* dual beacon: 0

* dual CTS protection: 0

* STBC beacon: 0

* L-SIG TXOP Prot: 0

* PCO active: 0

* PCO phase: 0

WMM: * Parameter version 1

* u-APSD

* BE: CW 15-1023, AIFSN 3

* BK: CW 15-1023, AIFSN 7

* VI: CW 7-15, AIFSN 2, TXOP 3008 usec

* VO: CW 3-7, AIFSN 2, TXOP 1504 usec

http://ix.io/4vtc

http://ix.io/4vt2

**chewitt** · May 10, 2023 at 10:47 AM

Make sure the Wireless Regulatory Domain matches your country (or what the router is configured as). No idea why BT is not probing... but then I have low/no real knowledge of Allwinner hardware.

knedlyk · May 18, 2023 at 11:42 AM

Thanks, it helped for me too!

atari · January 4, 2024 at 3:08 PM

i have same box but wget http://ix.io/4tpc -O /storage/.config/firmware/brcm/brcmfmac4330-sdio.oranth,tanix-tx6.txt not working ,seems not working ix.io is down

**Da Flex** · January 4, 2024 at 7:56 PM

atari Correct. We are working on our own log server. Use something like PasteBin or HasteBin in the meantime.

**chewitt** · January 5, 2024 at 6:46 AM

LE 11.0.4 and LE12 nightlies already switched to using https://paste.libreelec.tv

Tanix tx6 no wifi & bt drivers

Similar Threads

Vorke z6 plus dtb / wifi+bt in kodi / VFD : which dtb ?