RPi 4 (LE 10.0.1) often shows Bootscreen only, starts only with 2nd try

Gerri83 · January 13, 2022 at 8:50 PM

Hi, I have a problem with 2x Rpi 4 with LE 10.0.1

The Configuration is:

RP4 No.1

connected to an AVR

Switching on and off via a wireless socket (only the RPi)

RPi No.2

connected to a TV

TV AND RPi are switched via a wireless socket

both have the original power supply

Both Rpi's usually do NOT turn on properly the first time they are turned on, RP #1 shows no picture at all

RPi Nr2 shows a black picture, the boot screen of LE and on the top left it says LibreElec Official 10.0.1 but there it hangs and goes no further.

If I turn both off and on again they usually go.....

Any ideas?

I suspect that Rpi #1 is not displaying a picture due to the AVR but has the same problem as #2.

**chewitt** · January 14, 2022 at 1:59 AM

No logs = No problem

Cillit · January 31, 2022 at 10:19 AM

I think your issue is already mentioned here:

Thread

LE 10.0.1 / Rpi4 / No picture after update from LE 10.0.0

Hi,

after the LE 10.0.1 update of my clean installed LE 10.0.0 from the LibreElec menu and a reboot i get no picture anymore. Only the blue screen of my Onkyo AV.

LE 10.0.0 runs fine since 6 Weeks.

Switched to the other HDMI out of the Rpi4.

Completely shutdown and start again the TV, AV Receiver and the RPi4.

Nothing special added in my config.txt.

Tried to add in cmdline.txt:

video=HDMI-A-1:1920x1080M@60

I can still reach Kodi via SSH and the Android Yatse app. Playing media, controlling CEC via TV…

Cris_

November 3, 2021 at 10:33 PM

The answer is to run

getedid create through ssh.

I had the same issue and this worked at least in my case.