Moin, I think I found a small bug that occurs immediately after a new installation (for me under x86)
I install LibreElec on another TV with a resolution of 1280xXX (I'm not sure if the resolution is important)
When I installed everything (I write it as it was with me) then used it and then changed the TV (connected the device to another TV) the system starts normally and you can also start add-ons and watch films The whole system hangs for about 5 minutes and no longer reacts to anything. The system can only be restarted via the power plug.
If I go to Settings after the restart - System is immediately asked Keep resolution even though nothing has been pressed, then the system sets the resolution to 1920xXX for me and everything works without problems!
But I don't have a log that happened 3 times after the reinstallation ... Reinstallation with a lower resolution, switch to a TV with a higher resolution, start film / TV - the system hangs!
The system runs stably after you have switched to the system and confirmed the immediate popup with YES!
Maybe you can check this issue!
Regards
