Are there people here they have the rpi4 with an working ambilight?
Please share your tutorials and pictures.
Many thanks
Rpi4 ambilight hyperion
-
harun-cuk17 -
November 3, 2019 at 9:07 AM -
Thread is Unresolved
-
Hi,
the same as a PI 3
-
Hi,
the same as a PI 3
does your ambilight working on the pi4 then?
Mine is with an problem. Green and white pictures the leds stays off. But the rainbow effect is working with the green light.
many thanks. -
Yes, my one works fine with PI 4 - with initial Alpha 1 (or2) Alpha Version.
Does it works with your Pi 3 ?
-
Hmm, are you sure your Pi4 is not defect? (GPIO Pins)
Strange, if your setup is working fine with Pi 3.
Your connection is fine ?
-
Hmm, are you sure your Pi4 is not defect? (GPIO Pins)
Strange, if your setup is working fine with Pi 3.
Your connection is fine ?
I tested in total 4 pi4 and the same result. How did you made your connection between the led strip and the rpi4?
many thanks
-
Hi folks!
Just take a look into this thread RPi4 1GB + LibreElec 9.1.002 + Hyperion Lights = no lights
In the first (edited) post you may find the solution for the initialize problem.
Thanks for the information to RPi + LibreELEC - RPI 4 Unable to initialize ws281x library. | Hyperion - Forum
I had to replace the binary hyperiond in location /storage/hyperion/bin
-
waschbaerbauch75 would this solution work for apa102 leds too? I currently have the issue where if Hyperion is running I cannot get a hdmi signal at all until I remove Hyperion all together and reboot my pi... RPi4 resolution set to 4K. Used to work perfectly on RPi3.
-
Mitch7391 i don't know - i only have WS2801 and WS2812b, so i can't test..
-
waschbaerbauch75 was the change dependant on a library or binary specific to you type of lights? Can you explain the fix a little bit more please so I can understand if it will help my lights?
-
Hi,
the same as a PI 3
How did you get it work on the pi4?
