Posts by dippes

Hello

I listen to Radio paradise.flac with the addon Tunein2017.

After about 30 minutes CPU-Kodi is rising to 118% and it stutters only.when playing with mp3 I have not yet noticed.

Is this due to Kodi or the addon?

Here is a Kodi.log

Hello

I have started up my third Raspi4 with Libreelec 10.0.0.

When I boot the Raspi and the TV is switched on later, there is no picture until the Raspi is rebooted.

What do I have to set so that there is a picture when the Raspi is switched on before the TV?

Thank you, now with these settings it plays smoothly.

My Raspis are equipped with "Kingston A400 SSD SA400M8/120G" not with sdcards.

Could it also be because the HDMI cable is 5 m long?

I have exchanged the devices.now the 4 Gig is connected to the Samsung TV.it also jerks with the 4 Gig.all two Pi's run smoothly on the Panasonic plasma.

The Samsung TV is a 4K and the plasma is a normal 1080 TV.

Does it have anything to do with that?

Yes, each of the Pis is hooked up to its own TV.

Now with 10.0, the processor load has dropped considerably.

Unfortunately, it still stutters.

I have no idea what to release with the whitelist. I need help with this.

E.g. the film has a resolution of 2 048:1152@23,976

But is not offered by my whitelist

Kodi Log

Hello

I have two Rpi 4 with Libreelec.10.0.One has 4 Gig and the other 8 Gig Ram.

Now I have noticed that the 8 gig in a movie (h 265) jerks at the 4 gig but it does not.

Does the 8 Gig still have to be set something?

I want to wrap this up now.

These instructions work perfectly with Libreelec 10.0

With Libreelec 9.2.8 the command "ir-keytable -a /storage/.config/rc_maps.cfg -s rc0" is lost with every restart.

I wanted to update the EEPROM bootloader of my Raspi 4 from 2021-03-18 to 2021-04-29.

After a system restart, however, I was offered the same thing. Now I don't know whether this worked or not.

Normally, if it has worked, it should no longer be offered in the WIF.

I put the command in an autostart.sh which is executed after every boot. now it's good.

Can't it be simpler?

Quote from Jocke.Sve

On LG soundbar (SL10YG) I had to turn on the setting "Auto Power On/Off" to make that work.

Yes is with me also so is unfortunately not in the supplied manual.have had to look in the Inet.

It works.

I plugged in another HDMI cable and another port from the TV (HDMI3 instead of HDMI1).

What still doesn't work is that the Surroundbar switches on when a signal comes from the Raspi and switches off when the Raspi shuts down.

Is there anything else I can do?

Now the sound works via the soundbar, but the TV remains dark

have removed the commands from config.text.

Perhaps there are now meaningful logs.

Connected directly to the TV

pastekodi

modetest | pastebinit

With connected soundbar

pastekodi

modetest | pastebinit

I have also tried several sound settings

With connected soundbar

Pastekodi

modetest | pastebinit

Connected directly to the TV

Pastekodi

modetest | pastebinit

Da Flex

Unfortunately, the commands in the config.txt did not have any effect either.

Could this also be due to my old Panasonic plasma?