Posts by djnice

    djnice , no logs no problem. TVH works really nice on le 9 from GDPR-2

    This is my log:

    Please provide a sample file. I think, these are 10 bit H.264 files.

    Looks like MVC support is close; see here. But, appears to half-rez output (even though full decode happens).

    The hw is good for 3D MVC, but in sw side needs the following: [link]

    • Working post process manager for 3D is needed. I remember on some older kernels this was borked; which is why Memphiz added support for SW fallback for 3D -> 2D.
    • Enable FP in amports
    • Set 3D mode to ON (signalled with AV Infoframe). This is why auto 3D switching doesn’t work properly under AML.
    • Set fp mode in sysfs (there’s a bug here, because AMLogic thinks the VIC mode is the same; so it needs to be reset twice).
    • Need proper hints detection so that Kodi sets codec to VFORMAT_H264MVC and pre-header feading works for amcodec.


    Edit. Sorry, I see you got the same answer on kodi forum.

    Code
    1. alias usb:v148Fp7601d*dc*dsc*dp*ic*isc*ip*in* mt7601usta


    In other words: pasting a small part of log is not useful at all. The line above shows that your device should be supported by mt7601usta kernel module. I can't help further.


    Thank you for your help, it works, we using an old LE version.


    It should be already supported by mt7601u driver included in my builds.


    I tried again, but not working, wifi does not appear in LibreELEC.

    Code
    1. Bus 001 Device 003: ID 148f:7601 Ralink Technology, Corp. MT7601U Wireless Adapter
    2. [email protected]] usb 1-1: new high-speed USB device number 3 using xhci-hcd
    3. [email protected]] usb 1-1: New USB device found, idVendor=148f, idProduct=7601
    4. [email protected]] usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
    5. [email protected]] usb 1-1: Product: 802.11 n WLAN
    6. [email protected]] usb 1-1: SerialNumber: 1.0


    It's not a single file, it should be a folder with 9082xs kernel driver source code. 9082xs.so from your shared folder is the kernel module that we need sources for. :)


    I asked, but the wifi manufacturer don't give the source code...
    The latest Tanix TX3 Pro have the same 9082C chipset :(