vdr-plugin-dvbapi and oscam not working (TCP Mode)

tecfreak · April 9, 2017 at 8:10 PM

Hello,

I have problems getting vdr-dvbapi and oscam to run on a Wetek Play2 which I bought for a friend.

In the vdr-backend-addon settings, I have set the dvbapi-plugin settings to ip/host=127.0.0.1 and port=8002. I think these are both default values and both are set properly in vdr's setup.conf.
In the oscam webint I configured the dvbapi module as follows:

Code

[dvbapi]
enabled                       = 1
pmt_mode                      = 4
listen_port                   = 8002
delayer                       = 75
user                          = vdr
boxtype                       = pc

Now, if I start the vdr-backend at first and oscam as second, I get the following error message in the oscam log:

Code

(dvbapi) ERROR: Could not init socket: (errno=98: Address already in use)

If I start both in reverse order, oscam doesn't show this error message, but vdr sems to crash repeatedly.

Someone an idea what is going wrong here?
I have almost the same setup/config on a x86 machine and it runs without any problems.

ty

zbigzbig20 · April 9, 2017 at 8:42 PM

Vdr still does not work good on Play2 . It is very unstable . I prefere to use Tvheadend now. I tested few times vdr with default port 2000 (this same listen port in oscam) and it worked but still unstable and with occasionally stutters

tecfreak · April 10, 2017 at 12:03 AM

Thanks, will give it a try.