vdr-plugin-dvbapi and oscam not working (TCP Mode)

  • Hello,

    I have problems getting vdr-dvbapi and oscam to run on a Wetek Play2 which I bought for a friend.

    In the vdr-backend-addon settings, I have set the dvbapi-plugin settings to ip/host=127.0.0.1 and port=8002. I think these are both default values and both are set properly in vdr's setup.conf.
    In the oscam webint I configured the dvbapi module as follows:

    Code
    [dvbapi]
    enabled                       = 1
    pmt_mode                      = 4
    listen_port                   = 8002
    delayer                       = 75
    user                          = vdr
    boxtype                       = pc


    Now, if I start the vdr-backend at first and oscam as second, I get the following error message in the oscam log:

    Code
    (dvbapi) ERROR: Could not init socket: (errno=98: Address already in use)


    If I start both in reverse order, oscam doesn't show this error message, but vdr sems to crash repeatedly.

    Someone an idea what is going wrong here?
    I have almost the same setup/config on a x86 machine and it runs without any problems.

    ty

    Edited once, last by tecfreak (April 9, 2017 at 8:13 PM).

  • Vdr still does not work good on Play2 . It is very unstable . I prefere to use Tvheadend now. I tested few times vdr with default port 2000 (this same listen port in oscam) and it worked but still unstable and with occasionally stutters

    Edited once, last by zbigzbig20 (April 9, 2017 at 8:43 PM).