MCE missing IR Protocols

hagaygo · February 5, 2017 at 8:08 AM

Hi every one.

I just installed 7.95.2 on top of 7.0.2 on my RPI2.

Migration took a while but worked just great except my remote didnt respond at all , only keyboard was working.

After fine tuning the problem i found out the ir-keytable was using only LIRC protocol :

Code

Found /sys/class/rc/rc0/ (/dev/input/event0) with:
Driver mceusb, table rc-rc6-mce
Supported protocols: unknown other lirc rc-5 jvc sony nec sanyo mce-kbd rc-6 sharp xmp
Enabled protocols: lirc
Name: Media Center Ed. eHome Infrared
bus: 3, vendor/product: 0471:0815, version: 0x0000
Repeat delay = 1000 ms, repeat period = 125 ms

after running :

Code

ir-keytable -p NEC,RC-5,RC-6,JVC,SONY,LIRC,OTHER

the remote just started working.

I added the line to my autostart.sh and its just fine for me , but i think you guys should be aware of the problem and the cause of it.

Keep up the good work.

hagaygo · February 12, 2017 at 6:05 AM

Just to update , also happens on 7.95.3.

**HiassofT** · February 12, 2017 at 9:32 AM

Can you try a clean install of 7.95.3 on a separate SD card and see if this works?

Do you have any local config/settings installed in /storage/.config/udev.rules.d, /storage/.config/rc_keymaps or autostart.sh? If yes, remove them, they could be interfering.

Also please post the output of these 2 commands on your non-working setup (without your ir-keytable in autostart):

Code

dmesg | paste
ir-keytable -v -a /etc/rc_maps.cfg -s rc0 2>&1 | paste

so long,

Hias

hagaygo · February 12, 2017 at 10:58 AM

paste results on :

ZBYQ

WDTW

**HiassofT** · February 12, 2017 at 1:35 PM

Logs look OK, have you tried a clean install / hard reset yet?

so long,

Hias
[hr]
BTW: dmesg shows that lircd-uinput is running - did you create a lircd.conf in .config?

hagaygo · February 14, 2017 at 6:58 AM

7.95.3 with clean install works fine (7.95.2 did not), not sure what was the problem with my old config.

MCE missing IR Protocols

Similar Threads

My MCE remote stopped working, changes to lirc?