Hello,
I do need some support. After some issues with a movie on my old setup (RPI3 with Kodi 18) I decided to upgrade my two existing setups (Onother was an Odroid C2, lol)
I had two RPI4 and one of them not in use, so I just used the LE USB creator and it worked out of the box. Initial setup was with a mikro-HDMI adapter to a HDMI-to-DVI cable on my monitor setup, then it went to my FHD TV. So far so good.
Now, I tried to install a fresh RPI5 but it stucks. Seems anything with graphics is wrong.
Initial SD Card setup works fine and looks great (tried Monitor, 4k TV and FHD TV)
Sometimes it stucks during boot. Showing just in corner the message "LibreELEC (official) 12.0.1"
Sometimes it starts "successfully" loading the initial Startup assistent from Kodi, but here is almost everytime the end. It does not show right. I can see that cursor is moving, and I can skip this menue by clicking several times enter, but even after a reboot it is showing just a few frames, no text...se pictures below.
Hardware setup:
Fresh new RPI5 with 8GB ram + active cooling
Original 27W power supply
Ethernet connection
16GB sandisk (tried 32GB verbatim as well, both would work on RPI 4)
And I have a second RPI without active cooling, same behaviour.
Any ideas?
