[UNOFFICIAL][Le11-10][RK3228/RK3229][box]Libreelec builds

Hi foxy,

please try to be a little more specific.

This is to avoid the stupid question like.. "are you sure you have a rockchip rk3228"?!

for example, can you tell me if libreelec starts from the sd card!? and the multitool?! Are you just having problems installing it on internal storage?!

Finally, could you send some photos of the board contained in your box?! MXQ PRO 4K can also contain amlogic or allwinner chips.

Thanks

Michele

Hi jaum20,

the startup error is very strange.

I see the kernel tries to set the gpu clock to 600Mhz which my build does not.

Did you use the dts of my build!? or someone you adapted!?

Thanks

Michele

jaum20 wich armbian?! legacy?! stable?!

I've a spare box, so I can try to reproduce the issue.

thanks

Michele

jaum20,

thank you so much for your precious support. Try doing the same thing they suggested in the past with this dtb that I am attaching (remove .txt extension).

I have a question, how did you install armbian?! Via usb cable, or multitool, or what?!

Hi jaum20,

try this build. It's a preview of the next update that I decided to do to include the fix for your problem.

Index of /test/

Keep in mind one thing though. Your problem is related to a boot component of your armbian installed in nand.

I won't go into too much detail but basically you have an opensource trustos (optee) that is loaded on boot (If you look at the log you sent me, the errors related to 'sip v2' are related to the fact that the opensource trustos is probably not compatible).

Libreelec instead uses the proprietary one because it gives you the possibility of having ddr3 scaling and startup via remote control.

Therefore, if you should have problems in this sense, the only solution is, in your case, to update the trustos you have in the nand. But this might give you problems with armbian.

If I remember correctly, armbian also switched to using the same trustos as libreelec at some point (maybe jock2 can help us with that).

So maybe the solution is even simpler and consists of some update that you can easily apply.

Quote from jaum20

Should I switch the dtb after install as showed on the post #2?

yes, mainly this is needed in order to configure leds and some other features.

Thanks a lot and let me know

Michele

@bemenaker, my builds are for rockchip rk3228/rk3229, not for rk3328 I'm sorry.

@pigwoz, you need to switch dtb as explained in the 2nd post ( "Initial Setup" section) using the one with suffix -ovclk.

Michele

Hi all,

new build of libreelec-10 available with:

- linux 5.10.180

- mesa 23.0.3

- fix boot from sdcard in some circustance (thanks jaum20 for reporting and testing and jock2 for solution)

Cheers

Michele

Hi jaum20

this is normal because libreelec 10 has an older version of fuse.

I can add it to my build, but can you please try this first (symlink to old fusermount)?

Cheers

Michele