Hi all,
I have issue with HDMI-CEC on RockPro64 on 10beta1 and nightly (20210420). Turning TV off and on again stops remote controller work. The only resolution is to keep TV on and reboot the system. Then remote controller works until I turn the TV off and on again. It worked perfectly on LE 9.2.6. so nothing to do with HDMI cable or TV itself.
Below are outputs from cec-ctl. Physical address and Logical address mask are changed when the TV goes the off and on cycle.
TV is ON, RockPro64 has been rebooted and RC works:
--------------------------------------------------------------------------------------------
Driver Info:
Driver Name : dwhdmi-rockchip
Adapter Name : dw_hdmi
Capabilities : 0x0000010e
Logical Addresses
Transmit
Passthrough
Connector Info
Driver version : 5.10.30
Available Logical Addresses: 4
DRM Connector Info : card 0, connector 61
Physical Address : 1.0.0.0
Logical Address Mask : 0x0010
CEC Version : 1.4
Vendor ID : 0x001582 (Pulse-Eight)
OSD Name : ''
Logical Addresses : 1 (Allow Fallback to Unregistered)
Logical Address : 4 (Playback Device 1)
Primary Device Type : Playback
Logical Address Type : Playback
TV has been turned off and on again, RC doesn't work:
--------------------------------------------------------------------------------------------
Driver Info:
Driver Name : dwhdmi-rockchip
Adapter Name : dw_hdmi
Capabilities : 0x0000010e
Logical Addresses
Transmit
Passthrough
Connector Info
Driver version : 5.10.30
Available Logical Addresses: 4
DRM Connector Info : card 0, connector 61
Physical Address : f.f.f.f
Logical Address Mask : 0x0000
CEC Version : 1.4
Vendor ID : 0x001582 (Pulse-Eight)
OSD Name : ''
Logical Addresses : 1 (Allow Fallback to Unregistered)
Logical Address : Not Allocated
Primary Device Type : Playback
Logical Address Type : Playback
Any ideas?
Thanks.