Beelink GS1 doesn”t boot nightly builds

Piet200 · September 27, 2020 at 2:06 PM

I try to install libreelec on my Beelink GS1, but the screen stays black.

Used different nightly builds on different sd cards. But no luck.

used 2 different tools, of which rufus is one.

It look likes that the Beelink GS1 is not supported at all.

Someone succeeded in installing Libreelec on this device ?

ClementP · September 27, 2020 at 8:16 PM

I have just installed the latest nightly and test it right now and everything works fine on my board.

Did you try with different HDMI cables? I know that I got some issues with the one provided by Beelink.

Regards,

Clement

ClementP · September 27, 2020 at 8:24 PM

If there is no improvement.
Could you take a High Res pictures of your PCB top and bottom?

To see if some components are different compare to my board.

Top and Bottom like those :
File:Beelink GS1 pcbtop.jpg - linux-sunxi.org
File:Beelink GS1 pcbbottom.jpg - linux-sunxi.org

**jernej** · September 27, 2020 at 10:00 PM Official Post

Piet200 Can you test LibreELEC-H6.arm-9.80-devel-20200927221911-c26924a-beelink-gs1.img.gz ?

Piet200 · September 28, 2020 at 5:53 PM

Quote from jernej

Piet200 Can you test LibreELEC-H6.arm-9.80-devel-20200927221911-c26924a-beelink-gs1.img.gz ?

That did the trick.

Thank you very much, this works perfectly!

**jernej** · September 28, 2020 at 6:29 PM Official Post

Great! Fix will be included in next nightly image.