No Picture on Samsung TV (Pi4)

  • Hallo Community,

    bin *neu* hier auf diesem Forum, beschäftige mich aber bereits eine Weile mit den Raspberries.

    Mein aktuelles Projekt ist ein Media-Center, auf Basis Raspberry Pi 4 Model B (4 GB) (Kit von Labists), mit LibreELEC 9.2.3, Kodi v18.7.1 (Leia).

    Klappt auch wunderbar, auf meinem "Entwicklungssystem" ("Alter" VGA-Monitor, mit Adapter auf HDMI0), Zugriff auf mein NAS mit Photos und Musik, alles wunderbar...

    Wenn ich den Raspi aber an meinem Samsung-TV, Modell "GQ43Q60RGTXZG", anschließe, dann bekomme ich einfach kein "Bild" auf dem Fernseher.

    Bereits verschiedene HDMI-Anschlüsse am TV versucht, mehrere HDMI-Kabel, diverse Einstellungen, die ich aus verschiedensten Foren gezogen habe, aber bringt Alles kein positives Ergebnis. Der Samsung-TV meldet immer & permanent "Kein Signal"... *frust*

    Der Raspi bootet aber ganz regulär, ich hab' über LapTop und "SSH" Zugriff d'rauf, kann die "/flash/config.txt" bearbeiten - mittlerweile schon zig Einstellungen ausprobiert - aber "Bild" aufs TV bekomme ich einfach nicht...

    Hat jemand schon ähnliche Probleme gehabt? Wie sind sie gelöst worden? Welche Einstellungen in der "config.txt" dazu notwendig?

    Hoffe auch Euer positives Feedback.

  • Klojum: Thanx for the Info.

    I thought there was also a German-language forum at libreelec.

    But in the future I will formulate my questions (and answers) in English in this forum.

    Da Flex: I tried these settings, unfortunately with the same negative result.

    Also changed the cable again, also checked and changed the settings on the Samsung TV.

    Again and again the message no signal on the TV.

    Frustrated. Because you just want to set up a small project and fail because of the image output on the TV. :(:cry::(

    Edited once, last by Klein-WieleFrank: Further information/s... (July 22, 2020 at 12:08 PM).

  • Happy...

    It now works with the new HDMI cable (amazon: "AmazonBasics HL-007333 Hochgeschwindigkeits-HDMI-Kabel, Typ Micro-HDMI auf HDMI, HDMI-Standard 2.0 - 1,83 meter (2-Pack),Schwarz").

    My Pi4 was not recognized directly, but with the Samsung configuration wizard the necessary settings could be made on the TV.

    The "tvservice" command returned the following results:

    [-l] 1 attached device(s), display ID's are : Display Number 2, type HDMI 0

    [-s] state 0xa [HDMI CUSTOM RGB lim 16:9], 3840x2160 @ 30.00Hz, progressive

    [-n] device_name=SAM-SAMSUNG