- Official Post
Is LE really updating itself without recreating a LibreElec SD?
Yes. Please post your config.txt.
4k on LibreElec + Raspberry pi 4
-
pasty1969 -
March 29, 2020 at 9:19 PM -
Thread is Resolved
-
-
Thanks for your support. Please find attachment.
-
- Official Post
Thanks, I had a look. Follow my advice, and make 4K / 60Hz the last line. Otherwise it can be overwritten by later settings of config.txt.
-
Da Flex: Putting it last line brings no effect in the settings unfortunately. Perhaps it is an issue with my Panasonic DXX789 ??
-
- Official Post
1) Usually the TV manual says, which HDMI modes are supported. (please check it)
2) If 1) is OK, the next part of the chain is the HDMI cable. That cable should comply HDMI 2.0 or 2.1 standard to be able to transfer high 4K data rate. (please check it)
3) If 1) and 2) is OK, you can enforce 4K / 60Hz by adding this lines to config.txt:
-
Da Flex: Unfortunately it is not explicitely given in the TV manual, only that 4K 3D is not supported. I always thought (and I can hardly find detailed specs) that the DXW784/DXX789 from Panasonic has a native 100 Hz Panel.
Besides hat I am using the HDMI Cable that came along my Raspberry 4 bundle (Micro HDMI to HDMI) from LABISTS going into my Yamaha RX-V681 and from this out to the TV. I will double check the complete cable chain nearby.
Thanks a lot
-
