Raspberry Pi TV HAT and COM8 Problem

Deckard_Threepwood · July 17, 2019 at 12:45 PM

Hello,

I have recently just purchased and setup a TV HAT DVB-T/T2 for my Raspberry Pi 3.

I have successfully installed LibreElec, Kodi and Tvheadend and the system works fantastically apart from I can’t get any of the channels from the Mux COM8

Frustratingly these are the channel I would most like to be available, Quest, NOW 80s and NOW 90s.

When the same coaxial cable and aerial are plugged into my Humax box the channels on Mux COM8 work fine.

Would appreciate any help.

**Iridium** · July 17, 2019 at 5:24 PM Official Post

I assume you used a pre-defined TVH MUX - uk.<transmitter>

If so, this is more than likely an out of date file. Check the frequencies in TVH against those from your transmitter.

If your not too sure what you're doing, let me know what your transmitter is and I can have a look.

Deckard_Threepwood · July 17, 2019 at 8:38 PM

Hi thanks for your help and response.

Emley Moor is the transmitter I'm using.

Deckard_Threepwood · July 17, 2019 at 9:54 PM

did some googling with your advice and got it sorted, thanks again

Mario77 · July 18, 2019 at 12:59 AM

Quote from Deckard_Threepwood

did some googling with your advice and got it sorted, thanks again

May i ask if Now 80's and Now 90's are available on Hannington Transmitter?Never seen them before in scans..

Mario77 · July 18, 2019 at 1:05 AM

Wll if it's same mux for Quest it should be 626Mhz but for some reason I don't get them..

**Iridium** · July 18, 2019 at 9:53 AM Official Post

Now 80s and Now 90s for Hannington are on Com8 C56 754.0MHZ - also Quest HD and BBC4 HD

See Hannington

Mario77 · July 18, 2019 at 11:49 AM

On 746mhz I got 12 more channels which weren't listed before..

Just tried setting up a mux with 754Mhz and it's giving me exactly the same channels of 674Mhz.