My Zotac MCE Remote stop working after 9.0.0 Update

Charlie_743 · February 15, 2019 at 6:28 PM

Hi

Sorry for bad english.

I have Zotac nano with built-in ITE8713CIR and Zotac MCE Remote.

First used openelec, then migrated to Libreelec, the problems started with 8.2.5, but I just turned off the Libreelec settings/services lirc service and everything worked.

After upgrade to 9.0.0 i can't off lirc. What do I do now, this function is no longer in the settings.

I read theme My MCE remote stopped working, changes to lirc? and tried these advices, but nothing happened, the remote still don't work

Now after clean install 9.0.0 i see this

Code

LibreELEC:~ # ir-keytable
Found /sys/class/rc/rc0/ (/dev/input/event5) with:
    Name: ITE8713 CIR transceiver
    Driver: ite-cir, table: rc-rc6-mce
    lirc device: /dev/lirc0
    Supported protocols: other lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6 sharp xmp 
    Enabled protocols: lirc 
    bus: 25, vendor/product: 1283:0000, version: 0x0000
    Repeat delay = 500 ms, repeat period = 125 ms

And this

Code

LibreELEC:~ # ir-keytable -t
Testing events. Please, press CTRL-C to abort.
69.361939: lirc protocol(rc6_6a_32): scancode = 0x80340459
69.468673: lirc protocol(rc6_6a_32): scancode = 0x80340459
70.571532: lirc protocol(rc6_6a_32): scancode = 0x8034845b
70.678315: lirc protocol(rc6_6a_32): scancode = 0x8034845b
71.228069: lirc protocol(rc6_6a_32): scancode = 0x80340458
71.333716: lirc protocol(rc6_6a_32): scancode = 0x80340458
71.766740: lirc protocol(rc6_6a_32): scancode = 0x8034845a
71.872466: lirc protocol(rc6_6a_32): scancode = 0x8034845a

Help please

**Da Flex** · February 15, 2019 at 9:08 PM Official Post

IR remote control errors are a known problem on LE 9.0. Please read this thread.

jbinkley60 · February 16, 2019 at 12:40 AM

I'd suggest folks read this wiki page with regards to changes in IR controls with v9.0. I was able to resolve the issues I had with my IR controller since lirc is no longer supported with v9.0 .

his.dudeness · February 17, 2019 at 10:54 AM

Hi,

I've got an "original" Microsoft MCE remote with the USB receiver that came with it.

Looks like this: xbmc_mce_remote_control.jpg

Since the upgrade from 8.x to 9.0 it stopped working as well.

The usb receiver seems to work as the little led flashes when I press a button on the remote.

LibreELEC is just not reacting to it.. -_-

Regards

Michael