NUC7PJYH- Remote communication Server - failed to start

Sniffer · February 14, 2019 at 11:13 PM

Hi all

You may have seen my other thread noting I cannot get the infrared remote to work from a clean install on brand new nuc.

I’m getting a message as follows on my NUC7PJYH- Remote communication Server - failed to start

Could this be anything to do with my remote control issue ?

My log addresses if I’ve done this right are -

Any help appreciated

Jamie

duck7000 · February 15, 2019 at 8:21 PM

For the remote communication server failed message do this:

Go to settings/libreElec/network and enable wait for network to be online

Message will be gone after that

Sniffer · February 18, 2019 at 6:27 PM

Thanks for the reply . Whilst that has stopped the message , it delays boot time a littlW.

Is that masking the issue really? Is there a fix ?

Just wondering that’s all

Thanks

duck7000 · February 18, 2019 at 7:35 PM

The delay is intended, the message you have been noticed comes from the network not being up and running before libreelec starts

So Libreelec waits until network comes online.

You can set the waiting time but it doesn't bother me personally

Sniffer · February 19, 2019 at 2:11 PM

Ok thanks . I’ve not had the message before on my old nuc , but maybe because this nuc has ssd it’s bootinh a lot faster .

Thanks

Similar Threads