Wetek Core - Cannot access "Kodi Add-on repository"

bhd1 · May 6, 2018 at 3:59 PM

Hi,

I have recently installed the newest version of LibreElec on an SD card (fresh install), on my Wetek Core.

When I try to open the "Kodi Add-on repository" it just loads for about 30 seconds, and then I get following error message:

"Could not connect to repository"

It's the same when I try to enter "LibreElec Add-ons"

Does anyone know what the problem is?

Thanks!

**Klojum** · May 6, 2018 at 10:40 PM Official Post

Try enabling the "Wait for network" option in the LibreELEC Settings Add-on. Then reboot.

**CvH** · May 6, 2018 at 10:43 PM Official Post

btw I checked the repo and it should work, maybe force update of the repo ?

bhd1 · May 6, 2018 at 11:27 PM

Quote from Klojum

Try enabling the "Wait for network" option in the LibreELEC Settings Add-on. Then reboot.

Still the same problem...

bhd1 · May 6, 2018 at 11:27 PM

Quote from CvH

btw I checked the repo and it should work, maybe force update of the repo ?

How do I do that?

bhd1 · May 6, 2018 at 11:36 PM

I noticed one thing...

When I boot into WeOS (internal storage) I have similar problems. Seems like the box is not connected to the network, although I have always been connected through ethernet cable...

I also tried to connect through WiFi, but only got error message and couldnt connect.

I have no problems with other devices connected through ethernet and WiFi.

Can it maybe be some hardware issue with the box?

**CvH** · May 7, 2018 at 7:41 AM Official Post

Do you setup you network at the LE Settings addon?

Could you access the box over?

bhd1 · May 23, 2018 at 10:14 AM

Thanks everyone for your answers!

The problem had nothing to do with the Wetek Core or LibreElec.

The LAN port that the box was connected to stopped working!

I replaced the router and everything is working just fine now!

Again, thanks alot!