Black Screen while booting LibreELEC RPi2

Good afternoon everyone,

It is my first on the forum, I don’t know if there is a presentation post where to write but I was unable to find it.

Marco, from Italy:)

I just got my Raspberry Pi3.

During the first setup this morning, I was prompted to install both Rasbian and LibreELEC.

The installation went through the end properly. I got the success confirmation on the screen.

Now, when I try to boot Rasbian it will just boot fine.

When I try to boot LibreELEC, i just get to a blank black screen.

The Pi3 is connected via HDMI to a 52” Sharp Aquos(5 years old).

I tried to change the /boot/config.txt file removing the # to both the hdmi instruction. But the I still got black screen on LibreELEC. And Rasbian is booting in VGA quality 800x600. So i put the # back.

What other troubleshooting step can i follow?

The only weird thing is that I have a Raspberry Pi3, but LibreELEC had “Pi2” written next to the system. Is this the problem?

Marco

Quote from Klojum

We prefer to use our own setup/image file, and leave Raspbian for what it is. No need to complicate things.

You can use the LibreELEC USB-SD Creator to make the LibreELEC setup on your RPi micro sd-card.

The RPi2 file is for both the RPi2 and RPi3 models. They use the same image file.

Thank you for your answer and help!

Is it possible to keep the double boot at the start up? Or is it going to erase the Raspbian “partition” as well?

Best regards,

Marco