Good afternoon everyone,
It is my first on the forum, I don’t know if there is a presentation post where to write but I was unable to find it.
Marco, from Italy:)
I just got my Raspberry Pi3.
During the first setup this morning, I was prompted to install both Rasbian and LibreELEC.
The installation went through the end properly. I got the success confirmation on the screen.
Now, when I try to boot Rasbian it will just boot fine.
When I try to boot LibreELEC, i just get to a blank black screen.
The Pi3 is connected via HDMI to a 52” Sharp Aquos(5 years old).
I tried to change the /boot/config.txt file removing the # to both the hdmi instruction. But the I still got black screen on LibreELEC. And Rasbian is booting in VGA quality 800x600. So i put the # back.
What other troubleshooting step can i follow?
The only weird thing is that I have a Raspberry Pi3, but LibreELEC had “Pi2” written next to the system. Is this the problem?
Marco