Posts by vbat99

Already answered on MC forum.

Thanks for the conformation this is fixed in latest beta.
off to download and test.

Believe this is resolved in milhouse builds, and hopefully in the next beta

High 10 are out of the scope of the graphics chip to decode, so it is done in software I believe.

There has been plenty of talk on the Kodi forum under milhouse test builds, regarding high 10.

I suggest reading or searching that thread. Can't post URL from my Phone sorry.
[hr]
LibreELEC Testbuilds for RaspberryPi (Kodi 17.0)

Best you mention what make and model the Dongle is.
On pi 2 SSH in and post output of
lsusb
With Dongle attached.

Possible due to setting not saving on shut down?

Can't help but an idea to test.
Power off, disconnect power cord, press power button for 5 ish seconds to drain residual power.
Reconnect power cord and start the PC.
Does that start correctly?
if so, maybe power supply problem.

Just after guess. Good luck.

Or use a Gigabit switch instead of a low cost hub.

A switch can manage network traffic better.

Don't believe you can have both wired and wifi active on same network.

Maybe wrong on this, but usually it's one or the other.