Also, any way to start process at box reboot i.e. something from autostart?
It should be configured as a service and enabled with systemd. Review the status with
systemctl status | grep syncthing
And be sure it is started automatically with
systemctl enable service.system.syncthing
or you can put the tar in ~/.update folder
Good news, confirmed VTV is working with CE 8.90: DVB/DTV Extension Board for VIM2 (VTV) - Hardware and Peripherals - Khadas Community
There is no data stream from demodulator. Demodulator can be connected for parallel (GPIODV_0 - GPIODV_7) or serial (GPIODV_0) data transfer.
K-series boxes and WP2 use parallel and VIM2 use serial. Kind of data transfer for kernel modules (aml_dmx) is set via dtb. But driver is hard coded for parallel transfer. For future investigating and testing without physical HW is for me impossible.
Do you mean that driver doesn't have capability to manage serial data transfer or, is it a problem of pin assignments? Is the last DTB you have sent correct?
What about this patch? (it solved the problem with the Android kernel version) Could be it applied to the S912 project?
Sorry, I can't help you more without hw.
You've got a lot with blind eyes! Thanks for your patience 
Pls install LE 9.0 on new SD card and install TVH from LE repository.There is TVH 4.3-902. Try to setup single network 19.2E with autodiscovery (new muxes + changed muxe ). Add manually single transponder e.g. 19.2E 10817.5V and scan it (change scan status to active and save it).
Now with Tvheadend 4.3-902 ~ LibreELEC Tvh-addon v9.0.115 . Same result: not services detected (TVH problem?). I attach tvh and dmesg logs.
Shoog DVB-S is working in Android. I don't undertand your message. Everyone here is spending time to share, no obligations, no demanding messages...
Try to use this gxm_kvim2.zip .
Thank afl1
I am trying that DTB with LE-8.2.2.3 from kszaq and it seems to scan, but not tunning. I attach the TVH log for DVB-S and DVB-T.
By the way, the predefined muxes configuration for Astra19.2E in the TVH 4.2.5 from LibreELEC repo 8.2.113 is wrong and I have had to manually add 3 in order to test (I think data is right, from kingofsat listings).
Just installed the android firmware with VTV drivers (VIM2_Nougat_vTV_V171024.7z) and it works perfectly (including a 4K channel). Here the dump of DTB partition and the dts.
I am trying LE 8.90.1.1 + proposed DTB by afl1 in this thread and dmesg says "i2c i2c-1: avl6862: attach failed reading id"
Please afl1 , can you put the right links to the LE and DTB images intended to test the khadas vim2 pro + VTV expansion?
