[CLOSED] - Share network from wlan0 interface to lan0 in bridge mode

1st Official Post

    Hi,

    I need some help setting up the tether interface.

    Is it possible to configure the "tether" interface in Bridge mode so that the device connected to the Rasp Ethernet port has an IP of my network, assigned by the DHCP of my router?

    I already managed to enable the interface, however, when connecting some device to the Ethernet port of Raspberry the device assigns IP 192.168.1.2, without internet access.

    My network has the following range.

    Range: 192.168.0.1 - 192.168.0.254

    Mascara: 255.255.255.0

    Gateway: 192.168.0.1

    I searched several places and tried several things, without success.

    If anyone can give me some support, I'm grateful.

    Edited once, last by gabrielsutil (September 13, 2017 at 8:22 PM).