Wetek - Error during NAND install

calex71 · January 9, 2017 at 12:06 PM

Hi all,

I had nand corruption on my Wetek Openelec box (running Libreelec 7.0.2 and recently updated to 7.0.3) so I needed to do a clean nand install.

I got the 7.0.3 files and reflashed it , it sits on the libreelec splash screen for a long time then returns the following error:

*** Error in mount_storage: mount_common: Could not mount /dev/data ***
### Starting debugging shell... type exit to quit ###
sh: can't access tty; job control turned off
# _

Any ideas? I've tried it 3 times and get the same error returned.

Many thanks.

calex71 · January 9, 2017 at 4:01 PM

UPDATE : Got it installed

I found this thread before posting earlier LibreELEC

but my factory_update_param.aml didn't have the wipe data or cache commands . Checked my pc for the 7.0.2 version and it's factory_update_param.aml had those so I edited the 7.0.3 one on my card and added those in and the install worked correctly

**Saxnot** · January 31, 2017 at 9:25 PM

I also own an WeTek OpenELEC. I tried to install LibreELEC-WeTek_Play.arm-7.0.3.zip . I got the error on the boot splash:

Code

Starting debugging shell... type  exit  to quit ###
can't access tty; job control turned off

After that I also added those two lines calex71 mentioned, so the file factory_update_param.aml containes:

Code

--update_package=/sdcard/LibreELEC-WeTek_Play.arm-7.0.3-update.zip
--wipe_data
--wipe_cache

I tried again, and the installation works fine. Thanks for the hint.