ir-keytable, does not work with IFFALCON TV remote control

Maltsev.v.v · March 30, 2025 at 9:29 PM

I'm launching

Code

ir-keytable -p lirc -p rc-5 -p rc-5-sz -p jvc -p sony -p nec -p sanyo -p mce_kbd -p rc-6 -p sharp -p xmp -p imon -p rc-mm

Code

ir-keytable -t

nothing happens. All other remotes show scanning. But not Iffalcon.

Then I decided to test lirc. I installed bookworm and lirc, ran irrecord, and the file was created.

iffalcon.lircd.conf

Code

begin remote

  name  IFFALCON_TV
  bits           24
  flags SPACE_ENC|CONST_LENGTH
  eps            30
  aeps          100

  header       3968  3996
  one           489  1999
  zero          489  1007
  ptrail        489
  gap          65238
  min_repeat      7
#  suppress_repeat 7
#  uncomment to suppress unwanted repeats
  toggle_bit_mask 0xA30A3
  frequency    38000

      begin codes
          KEY_UP                   0xF590A6
          KEY_DOWN                 0xF580A7
          KEY_LEFT                 0xF560A9
          KEY_RIGHT                0xF570A8
          KEY_OK                   0xFF400B
          KEY_EXIT                 0xF060F9

      end codes

end remote

Display More

This is an Android TV, so CEC does not work very well.

Can you help, is it possible to solve the problem?

Is it possible to control libreelec with this remote?

**HiassofT** · March 30, 2025 at 10:26 PM

You could try running the lircd.conf through lircd2toml.py to convert it into a toml file:

Code

lircd2toml.py -o iffalcon.toml iffalcon.lircd.conf

then load it via ir-keytable -r (or add it to rc_maps.cfg) and check if it works.

If it doesn't work well you could use lirc on LE (yes, it's still there) - just copy the lircd.conf file to /storage/.config/lircd.conf

so long,

Hias

Maltsev.v.v · March 30, 2025 at 11:07 PM

thank you very much for your help

ir-keytable, does not work with IFFALCON TV remote control

Similar Threads

[RPi4] My TV remote controller stopped working on KODI!!!

Remote control buttom mapping

TV remote control doesn't work in 12.0.2