Raspberry Pi4 - LE 11.0.3 - No video signal on hdmi0, no CEC on hdmi1

Hello,

I am facing this problem at the moment: clean install of LE 11.0.3, if I connect the HDMI cable on the port closer to the power input, the TV reads the device via CEC but I get a no signal error, if I connect the HDMI cable to the other port I get a video/audio signal but CEC does not work and I can't use my TV remote to control Kodi.

Could you please help me?

This is my config.txt:

# SPDX-License-Identifier: GPL-2.0-or-later
# Copyright (C) 2009-2014 Stephan Raue (stephan@openelec.tv)
# Copyright (C) 2016-present Team LibreELEC (https://libreelec.tv)
################################################################################
# Bootloader configuration
# config.txt version v1 (do not remove or change this line!)
################################################################################
# For more options and information see
# http://rpf.io/configtxt
################################################################################
# Default GPU memory split, 76MB are needed for H264 decoder
gpu_mem=76
# Don't send initial active source message.
# Avoids bringing CEC (enabled TV) out of standby and channel switch when
# rebooting.
hdmi_ignore_cec_init=1
[all]
################################################################################
# Use distroconfig-composite.txt instead of distroconfig.txt to enable
# composite video output.
# The composite video mode needs to be configured in cmdline.txt:
# For PAL add: video=Composite-1:720x576@50ie
# For NTSC add: video=Composite-1:720x480@60ie
################################################################################
include distroconfig.txt
#include distroconfig-composite.txt
# uncomment to enable analog audio output
#dtparam=audio=on
#audio_pwm_mode=1
# uncomment to enable infrared remote receiver connected to GPIO 18
#dtoverlay=gpio-ir,gpio_pin=18

Do you need the output of something else?

Thank you.

It did work before. To be honest, HDMI-1 didn't work before, now it's the opposite.

I started with LE 9, and it was working fine.

Then I had a problem (I can't correctly recall what it was) where Kodi froze, I had to reboot the Pi4. After the reboot, I had a display problem (it was like the TV was divided in 4 monitor and Kodi was only show on the top left quarter) and I tried to upgrade to LE 10 (without doing a clean installation). Since the issues were still present, I decided to do a clean installation of LE 11. Video was back fine, but CEC wasn't working (probably because I switched to hdmi1 port).

Now if I switch back to HDMI-0 port, I have no A/V, and I would like to remain on LE.

Hi Da Flex,

I appreciate your help, but the issue disappeared by itself or I am just st*pid.

I just rebooted the Pi4 with the HDMI cable already connected to HDMI-0 and both CEC and A/V started working.

The thread can be closed.

Quote from HiassofT

Now it gets confusing, over at the kodi forum you posted that you got it working.

https://forum.kodi.tv/showthread.php…8635#pid3188635

Please don't double post to different forums as this creates double work (lots of us developers monitor both forums).

If you double post please keep both your threads up-to-date to avoid confusion and unnecessary work for us devs.

so long,

Hias

Display More

That thread was from January.

I though to try my luck here, and when I was about to post that the problem disappeared, I got a error because I had to wait 2400 seconds to post a message again.