Hello, I've been trying to setup LE 10 on a raspberry pi 4. Whenever I watch something with DTS-HD MA sound, everything goes fine. However when I turn the TV and AVR off, then back on again the next day to watch something else, the sound falls back to stereo. My AVR detects only stereo signal coming out of the Pi, that is until I turn off and on back again the Pi when the AVR is turned on, then my AVR receives the correct DTS-HD-MA signal.
When going into the audio settings when the AVR is receiving only stereo, I can see that all settings related to DTS-HD and DTS-HA MA are not present. But when I go back into those settings after rebooting the pi with the AVR on, the settings are back.
So basically when I want to watch something with HD sound, I need to turn off and on the pi everytime, but with the AVR turned on. This issue was not present on LE 9.2.x. Is there any way I could make the HD sound settings to stick between AVR reboots?
Thanks!