How do I get the RPi3 to automatically switch refresh rates with a clean install of LE 9.2.6?
The connected display supports:
Code
tvservice -m CEA
Group CEA has 21 modes:
mode 1: 640x480 @ 60Hz 4:3, clock:25MHz progressive
mode 2: 720x480 @ 60Hz 4:3, clock:27MHz progressive
mode 3: 720x480 @ 60Hz 16:9, clock:27MHz progressive
mode 4: 1280x720 @ 60Hz 16:9, clock:74MHz progressive 3D:FP|TopBot
mode 5: 1920x1080 @ 60Hz 16:9, clock:74MHz interlaced 3D:SbS-HH
mode 14: 720x480 @ 60Hz 4:3, clock:54MHz x2 progressive
mode 15: 720x480 @ 60Hz 16:9, clock:54MHz x2 progressive
(prefer) mode 16: 1920x1080 @ 60Hz 16:9, clock:148MHz progressive
mode 17: 720x576 @ 50Hz 4:3, clock:27MHz progressive
mode 18: 720x576 @ 50Hz 16:9, clock:27MHz progressive
mode 19: 1280x720 @ 50Hz 16:9, clock:74MHz progressive 3D:FP|TopBot
mode 20: 1920x1080 @ 50Hz 16:9, clock:74MHz interlaced 3D:SbS-HH
mode 29: 720x576 @ 50Hz 4:3, clock:54MHz x2 progressive
mode 30: 720x576 @ 50Hz 16:9, clock:54MHz x2 progressive
mode 31: 1920x1080 @ 50Hz 16:9, clock:148MHz progressive
mode 32: 1920x1080 @ 24Hz 16:9, clock:74MHz progressive 3D:FP|TopBot
mode 34: 1920x1080 @ 30Hz 16:9, clock:74MHz progressive
mode 35: 720x480 @ 60Hz 4:3, clock:108MHz x4 progressive
mode 36: 720x480 @ 60Hz 16:9, clock:108MHz x4 progressive
mode 37: 720x576 @ 50Hz 4:3, clock:108MHz x4 progressive
mode 38: 720x576 @ 50Hz 16:9, clock:108MHz x4 progressiveat the gui:
Code
tvservice -s
state 0xa [HDMI CEA (16) RGB lim 16:9], 1920x1080 @ 59.94Hz, progressiveFor example enable Full HD HDMI modes for Stereoscopic 3D is set. But when I play 3D MVC content this is the mode I get:
Code
tvservice -s
state 0xa [HDMI CEA (16) 3D T&B RGB lim 16:9], 1920x1080 @ 59.94Hz, progressiveIf I manually change the refresh rate to 23.98 in the GUI before starting playback I will get:
Code
tvservice -s
state 0xa [HDMI CEA (32) 3D FP RGB lim 16:9], 1920x1080 @ 23.98Hz, progressiveI've whitelisted all the 1080p resolutions my display supports (like 1080p24, 1080p23.98, etc.), but it won't switch into any of them automatically for 2D or 3D content. It just always stays at what the GUI is set to. There is no option to enable automatic refresh rate switching in the GUI like I've seen in older versions on other HW, I checked both Advanced and Expert modes.
