Allo Digione cannot be selected

I installed Libreelec 9.20 on my Raspi 3+.

But unfortunately my Allo Digione is not available.

Is the card not supported?

Another thread says that the card is supported, but as I see there is no driver module available.

Is there still a way to get the card?

Quote

you could try adding this to your config.txt

Which config.txt is meant here?

I read the wiki but found no clue.

Are there no understandable instructions on how to integrate the Allo Digione into the system?

The module "i2c_bcm2835" is now loaded during system startup.

is there anything missing now?

RASPI-WOHNZIMMER:~ # lsmod
Module                  Size  Used by
hci_uart               40960  1
btbcm                  16384  1 hci_uart
serdev                 16384  1 hci_uart
bluetooth             434176  3 hci_uart,btbcm
ecdh_generic           28672  1 bluetooth
8021q                  28672  0
rc_medion_x10_or2x     16384  0
ati_remote             20480  0
brcmfmac              204800  0
rc_core                40960  3 rc_medion_x10_or2x,ati_remote
brcmutil               16384  1 brcmfmac
cfg80211              512000  1 brcmfmac
rfkill                 24576  3 bluetooth,cfg80211
bcm2835_gpiomem        16384  0
fixed                  16384  0
i2c_bcm2835            16384  0

But into which .conf the "dtoverlay=allo-digione" should be put I couldn't get it out.

Thanks works now

Quote from Iridium

No idea where you got the idea to include i2c_bcm2835

I thought that was the allo digione driver