Create custom resolution/refresh

sonik · September 3, 2019 at 1:46 PM

Hi,
I use LibreElec on a dedicated htpc connected to an DLP Projector. It supports from 24hz up to 120hz
On windows I can add some custom resolutions like 720p@48hz and 720p@96hz.
I would like to add some resolutions to OpenElec but don't know how.

**Da Flex** · September 3, 2019 at 4:42 PM Official Post

This is how it works: The output device is telling LibreELEC all supported resolutions / refresh rates (goes automatic over HDMI).

At the LibreELEC settings you can select one of those resolutions / refresh rates as your default.

sonik · September 3, 2019 at 5:57 PM

Yeah LibreElec shows what the hardware says it support.
But I want to add refresh rates not reported by the device. There´s any way to do this?
Movie Projectors can be very flexible with resolution and refresh rate.

**Da Flex** · September 3, 2019 at 6:31 PM Official Post

Quote from sonik

But I want to add refresh rates not reported by the device. There´s any way to do this?

I'm not sure. I gave an advice here, but I still have no feedback. Adding res. / refresh data should work the same way.

sonik · September 18, 2019 at 3:22 PM

Not worked.
Also there's a lot of resolution settings on that file that does not appear as selectable on the interface.
I do think it only uses the info it gets from the device's EDID.
Any advice?