Basic question on Rpi3 and GPIO control.

1st Official Post

    Hi Guys, new to LibreELEC but using OpenELEC and Kodi for years now.

    Looking to move over to LibreELEC but have a question on Rpi3 and GPIO control.

    1) Does the base build of LibreELEC have RPi.GPIO support built in or do i need to find a addin like this RPI GPIO BUT a LibreELEC repo.

    2) If not, basically just need to run a simple task as shown below which turns my power Amp on and off if Kodi is left on for more than 10mins (this code is triggered from a more complex custom python script I have running, but out of scope for now)

    Thanks again and sorry if this is already covered. There were a lot of hits in the search for GPIO, but dealing with a config.txt file? not sure if that works for me...

    AG

    Code
    import RPi.GPIO as GPIO
GPIO.setmode(GPIO.BCM)
ch23 = 23
GPIO.setup(ch23, GPIO.OUT)
GPIO.output(ch23, True)
print "Set pin High"