I finally found issue in switching standards. Issue was in setting voltage for LNB (13V/18V for V/H). After switching standard to dvb-s voltage is reset (to vertical), but tvheadend consider the voltage is already adjust. To save this issue is necessary in LNB settings check option 'Turn off LNB when idle:'.For multistandard config is necessary:
- LE 8.0.0d-I
- tvheadend42 8.1.112a
- tvheadend: Configuration->DVB Inputs->LNB->Turn off LNB when idle: checked
- tvheadend: for every standard Maximum PIDs: 26
- tv headend: Configuration ->Channel/EPG->EPG Grabber Modules->Over-the-Air: EIT: DVB Grabber->EnabledOTA EPG is not blocking any standard streaming.
Many thanks for your effort.
I've tested,epg works but not always work switching from dvb-t to dvb-s or dvb-s to dvb-t. ( no signal)
My debug.log
Posts by gor
-
-
tvheadend42 8.1.112Hi,
Super job, amazing. Many thanx.
Should I test tvheadend42 8.1.112 or tvheadend42 8.1.112a? -
Pls report versions, tested dvb-standards, tvheadend log...
For tvheadend trace log: linuxdvb, mpegts
I feel like in Kinder Garden.
Hi,
Thanks for great work.
clean install tvheadend 8.1.112a dvb-t dvb-s2
Dvb-s scan was ok, but dvb-t wad fail, with force and manually edited mux I was able to only one mux with 8 channels scanned and mapped.
Firstly works without epg I can switch dvs2 and dvbt channels, after reboot epg works but I got usually no signal , but sometime started dvb-t channels , but dvb-s not anymore.
debug.log with linuxdvb, mpegts -
registering mux for OTA EPGregistering mux for OTA EPG >>" For test is necessary disable OTA EPG in adapter settings "
-
Hi,
I 've installed LibreELEC-S905.arm-8.0-8.0.0c-I.img.gz and replaced dtb.img after that added the addon service.tvheadend42-8.1.110c.zip + pvr.hts-3.4.17.zip and disable update and no internet connection, but I got an error on Kodi error at pvr.hts-3.4.17 addon, tvheadend unreachable ( although ip was 127.0.0.1 in Tvheadend) and If I choose watch TV a got pvr is starting 0% and that's all.
Thanks for any suggestion.
Gor