Posts by codesnake

badkarmaboy Here you can find latest Android release for WeTek Play 2: WeOS v3.1 by OTA for WeTek Play 2 [Android Marshmallow 6.0.1] - WeTek Community Forum

Support for WeTek Core internal Bluetooth was added to LibreELEC long time ago. To use it you need to first enable Bluetooth in LibreELEC settings: LibreELEC->Services->Enable Bluetooth.

What LibreELEC build have you installed?

So LibreELEC boots now or not?

Insert your installation SD-card and in recovery menu select "apply update from EXT->Update from sdcard", then select the LibreELEC-WeTek_Core.arm-8.0.2-update.zip. After install is complete also run "wipe data/factory reset" from recovery menu. Then reboot.

philip5660 What files do you have on the SD-card you used to flash LibreELEC?

jamm Yes, most likely the problem appeared after the switch to lirc. I will check.

jamm What IR extender you use?

You will see that line in you full log (without grep -i dvb). Adapter 0 frontend 0 means first adapter and first frontend.

Unfortunately it is hard to tell why you get no results after a scan, probably your tvh config is wrong. I don't have DVB-C here, but DVB-T2 works just fine for me with the same tuner.

The driver first probes for mxl603 tuner, and if it is not detected, it tries to initialize ASCOT3 tuner. You can see next line in the log:

i2c i2c-1: Sony ASCOT3 attached on addr=60 at I2C adapter ffffffc01038f0e0

If you see DVB-C adapter in web interface, then adapter has been detected, why you write "no adapter, no frontend"? The messages in your log show normal functioning of the DVB driver.

@LIR1975 What happens when you press OK on LG's remote when WP2 is turned on?

You can take it here: LibreELEC 7.0 for WeTek Play 2 - WeTek Community Forum

You mean auto-repeat with original remote? On my WP2 it works just fine.

Unfortunately WeTek Play 1 doesn't support hardware decoding of H265 video, thats why you have high CPU load, because Kodi uses software video decoding in this case.
You may consider WeTek Play 2 that does support H265 decoding.

archercj As you you are asking this on LibreELEC forum, I think the answer is obvious

As far as I know OpenATV on WP2 cannot play Dolby Digital audio tracks.

Just try what is best working for you and use it. In my opinion Kodi works much better in LibreELEC than in Android.

Sepp I managed to reproduce your issue. Now I'm trying to find a solution for it.

alex0801 What satellite do you use and what FTA HD channels you have problems with? I'm asking to reproduce your issue.