Marciano , doc_bravn : dont you have lags when enabling the hyperion addon as described here? Hyperion issue: playback slowdown and halting.
The problem described in Hyperion issue: playback slowdown and halting.
at me too it is observed. After about 40 minutes of video viewing, the picture starts to slow down and go slow. It helps stop the play and restart the view.
My arduino baudrate runs great at 500000 with hyperion
What is your model of Arduino and which USB-UART chip is used in it? I have a model Arduino UNO R3 with a chip CH340G as USB-UART.
You'll need to modify the Hyperion firmware on the arduino, if you have the source, to match the baudrate you want to use.
Please read this reply to make sure that you pick a frequency that will work reliably with the arduino.
In the sketch for arduino the baud rate is 460800. In Hyperion settings, I also set the baud rate 460800. In the log Hyperion gives an error opening the port. I set the same baud rate in both the sketch and the Hyperion settings. It works only if I install the baud rate 115200 in the sketch and in the Hyperion settings the baud rate is 115200.
On all other values of the baud rate does not work and gives an error in the Hyperion log.
For the Ambilight and Hyperion backlighting, I connected to the Arduino UNO R3. If I set the baud rate to 115200, then everything works fine, but slowly. If I set the baud rate to 460800, the Hyperion log shows an error opening the RS232 port.
Works and does not give an error unless the baud rate is set to 115200. At any other baud rate values, it gives an error and Ambilight does not work.
Is it possible to correct the error and make it possible to use the baud rate more than 115200?
How can I fix the error and set the baud rate to 460800?
Does your build have a driver for CH340G USB-UART?
Does your build have a driver for CH340G USB-UART?
