I have it in the case with copper heat sinks and the 40mm fan, today at noon it had 57 degrees Celsius during a movie when it revved up.
I'll test it without the fan, but I'd prefer it with the fan because of the longevity 
When I tested the rpi4, it always ran into the limiter and the Rpi 4 consumed less power
Have you tried running without it? .. the boards are designed to run way hotter than most users are comfortable with.
not for a long time, but even the Pi 4 got too hot without an active cooler when playing videos and clocked down
I use the Pi 5 in my home cinema, so I want it to look good (or be inconspicuous) and be very quiet.
I currently have this case and have drilled 6 extra holes in it because I thought the ventilation would not be good, I only read later that the Pi 5 does not support fan control.
hi, do you know when a configuration of the fan trigger points for the RPI 5 will be available?
Unfortunately, it's terribly annoying that it keeps spinning up and down again.
Hi, i've tried it with the "SD Card Boot" Image from Pi Imager 1.7.3 but i only get a green screen and it doesnt work...
edit: and with 2 SD Card Image from here
https://github.com/raspberrypi/rpi-eeprom , same Problem
edit2: ok, the 2. Try with the January EEPROM has worked, thank you very much 
I wanted to make an Eprom Loader update in Libre Elec 10.0.3 and since then the RPI Imager always starts, even if I insert a blank SD card. I tried to cancel and installed Kodi and Ubuntu on the empty card but the RPI imager starts every time now...... is there any way to disable it?
Otherwise, my R Pi 4 is for the dogs 
hi, unfortunately the 10.0.2 update is not (yet) displayed, can someone tell me exactly which files I need to trigger a manual update via Samba?
edit: oh ok, i can use the whole .img........ 
Hi, I have a problem with 2x Rpi 4 with LE 10.0.1
The Configuration is:
RP4 No.1
connected to an AVR
Switching on and off via a wireless socket (only the RPi)
RPi No.2
connected to a TV
TV AND RPi are switched via a wireless socket
both have the original power supply
Both Rpi's usually do NOT turn on properly the first time they are turned on, RP #1 shows no picture at all
RPi Nr2 shows a black picture, the boot screen of LE and on the top left it says LibreElec Official 10.0.1 but there it hangs and goes no further.
If I turn both off and on again they usually go.....
Any ideas?
I suspect that Rpi #1 is not displaying a picture due to the AVR but has the same problem as #2.
Hi,
will there be an extra package with the update files?
Unfortunately, neither the manual nor the automatic update to 9.2.3 works for me (RPi 4 and 9.2.1).
