Posts by awiniar

Hi knaerzche,

Could you build image for bananapi m2 plus or give me a patch with your changes? I have the same issue and I can test image very quickly.

HI all,

Unfortunately I have the same problem on Allwinner BananaPi M2+. I check CEC settings and its set correctly ("ignore on switch off"). I try recompile image with old libCEC 4.0.5 but issue is still visible. I observe that after power on my TV, physical address on cec-ctl is set as f.f.f.f (should be 1.0.0.0). Restart kodi helps but is no good solution. On LE 9.2 CEC worked correctly.

Quote from jernej

Yeah, wifi is not priority ATM. Do you see any issues with items listed as supported in first post? Can I mark BananaPi M2P as supported?

For now:

- mainline kernel & U-Boot --> OK

- completely open source except GPU (Mali) driver (until Lima project is good enough for Kodi) --> OK

- latest Kodi --> OK

- zero copy decoding & rendering --> OK

- shared decoding & rendering code with other SoCs (with small adjustement for now) --> OK

- compared to OpenELEC images with BSP kernel, HDMI should work with any monitor automatically --> OK

- HDMI CEC (support depends on the board) --> OK

- multi channel HDMI audio (correct audio output must be selected) --> OK

- IR receiver (H3 only) --> NOT TESTED (I don't use this feature)

- Analog audio (H3 only) --> NOT TESTED (BananaPi M2P has no analog audio output)

I found one problem with wifi. In lib/firmware/brcm symbolic link brcmfcmac-sdio.txt shows to wrong file. Before change link to brcmfcmac-sdio.AP6212.txt wifi works perfect.

Quote from jernej

Can you test this image? libreelec-h3.arm-9.1-devel-20181229171500-417520b-bananapi_m2p.img.gz

If it works, I'll add it to list of supported boards.

Thank you so much. I'll start testing immediately.

Hi

I have a question about Bananapi M2P. This is Allwinner H3. Can I compile LibreELEC for this board?