Posts by jaylam

jaylam · Need help Intel Nuc jaylam August 11, 2018 at 12:26 AM

ok so I am tinkering and just disabled legacy boot in the BIOS so only UEFI is enabled, reinstalled 8.0.0 and it works......I don't get it.

jaylam · Need help Intel Nuc jaylam August 11, 2018 at 12:15 AM

Thanks, strange that it worked previosuly on version 8.0.2 before I tried to update it.

Have tried a new cable same thing, its a Pioneer VSX-922.

jaylam · Need help Intel Nuc jaylam August 10, 2018 at 11:55 PM

Hi all,

Wonder if someone can help, this is driving me mad.

So about a week ago I have LibreElec version 8.0.2 on my Intel Nuc which is connected to my av receiver which was working fine, stupidly I decided to try and update to the newest version then it stopped working. What would happen is it would start to boot, I would get a HDMI connection light on the avr then nothing, however I could ssh to it and if I reboot the Nuc I can get the BIOS up.

Did a fresh install same thing.

Now I have done a bit of playing about, if I install version 7.0.3 and I can set the resolution in LibreElec to 1080p.

Anything version over 8.0.0 I can install it but only get resolution 1280x1024

Anything version over 8.0.1 and higher I get the Intel Nuc splash screen with the message its just about to run the installer then screen goes blank and the HDMI signal light goes out on the avr but if I remove it from the avr and plug directly to the tv it displays.

Anyone got any ideas?

Nuc updated to the latest firmware.

Many thanks in advance, this is really driving me mad.

J