Posts by antimatter

Hello,

every few days my TV acts strange and switches to the HMDI 4 port while showing HDMI 4       (raspberry  ) in the OSD info. Yes, there are some blanks before the closing parenthesis. I don't have anything connected to HDMI 4. When I switch back to "HDMI 1 (MHL)" it takes max 10 seconds, and the TV switches back to HDMI 4 again.

I write in this forum, because I am running LibreELEC on a Raspberry Pi 3B+. That Pi is connected to an AVR and that AVR goes into HDMI 1 (MHL). This thing started a few ago and I think I also updated LibreELEC around that time from version 9.2 to 9.2.3. That is also the only change in my setup.

Yesterday, I was watching some Netflix on a FireTV stick, when I found something interesting on Youtube on my phone. I shared the video link with the Yatse app, which sends it to the Pi. There a Youtube addon will play that video. The video was already playing when I paused the movie on Netflix and then switched the AVR to the Pi. That's, when the TV started to think, HMDI 4 is the most important thing in the world.

I search for anything such as CEC and disabled it on every device: TV, FireTV stick, Pi... did not help. The only thing that stopped the crazy acting was cutting the power for all devices (except TV). Can someone help, please?

TV: Sony KDL-60W855B

AVR: Marantz NR-1604

Pi: 3B+ with LibreELEC 9.2.3 + FLIRC USB dongle

FireTV stick: on AUX-HDMI port @ AVR

Remote: Oneforall Smart Control 8 (URC 7980)

Thanks for replying. I will check this at the next opportunity.

I have a Raspberry Pi 1 running LibreElec. I also use this Streamzap remote control with it and it worked flawlessly for months.

Streamzap | Consumer Electronics : PC Remote : Overview

When I updated to version 8.2.5 I noticed that the remote control no longer works. Unplugging and plugging the IR-Reciver in again is a workaround in most cases. Sometimes, the OK button does not work after this and I have to unplug it again to make the OK button work, too.

Then I went back version by version, until it worked again. The version I reverted back to is 8.0.2. This is probably the version I used before the update. All other versions available must have a bug regarding the Streamzap remote: 8.2.0.1, 8.2.1, 8.2.2, 8.2.3, 8.2.4 and 8.2.5.

I have a partial dmesg fragment showing the relevant lines of the Streamzap remote. Unfortunately, I don't have the full debuglog and the lsusb output, because I read the "How-to bug-reports" when the Pi + remote were no longer within my reach. If it is about the VID/PID, those are visible in my dmesg fragment.