directly shut off after remote button press

    Hello Libreelec community,

    after updating to Libreelec 12 on my NUC i found that in opposite to before when I use my remote (with "Key_Power") there is a menu coming up asking if I want to suspend, shutdown, restart ... as I use the same remote command also for my beamer to shutof, I have no chance to switch somehting.
    I remember that in the past it was possibel to disable this menu, now I do not find it again?

    Or can I configure the "Key_Power" in a way that system will shutdown (or better hybernate) directly?


    Thanks!

    When using the Generic (non-Legacy) LE, it should work like that:

    Post

    RE: RPi4 GPIO using in LibreELEC

    I've been installed a power button and a status LED on my RPi3B+. This works for RPi4B, too. After SSH login, you can use the nano editor to create or edit all necessary files.

    Power Button Hardware Part

    Use GPIO03 (Pin #05) and the opposite Ground (Pin #06) to connect a push button for power on / off.

    Power Button Scripting Part

    Add dtoverlay=gpio-shutdown to config.txt.

    Switching off will let the shutdown menu appear.

    To shutdown instantly instead, create this …
    Da Flex
    August 17, 2019 at 11:58 AM