Zerotier disconnects

Grzesb · November 9, 2023 at 11:42 AM

Hi I have LibreElec 9.2.8.11 with zerotier.

It is connected to zerotier network but I have problem with connetion working. Putty works longer (but connection is very slow and after some time is dropping) and Vnc sometimes I can move coursor one or two times and connection freezes. connect

Ping is high and connections are dropped.

zerotier-one.ctl -q info

200 info 97xfxxx198 1.4.6 ONLINE

route

Kernel IP routing table

Destination Gateway Genmask Flags Metric Ref Use Iface

default DLink.home 0.0.0.0 UG 0 0 0 wlan0

192.168.5.0 * 255.255.255.0 U 0 0 0 wlan0

192.168.5.1 * 255.255.255.255 UH 0 0 0 wlan0

192.168.194.0 * 255.255.255.0 U 0 0 0 ztbto32yyo

/storage/.config/iptables.rules

iptables -F

sysctl -w net.ipv4.ip_forward=1

sysctl -w net.ipv4.conf.all.forwarding=1

sysctl -w net.ipv4.conf.all.rp_filter=2

iptables -t nat -A POSTROUTING -o wlan0 -j MASQUERADE

iptables -A FORWARD -i zt+ -j ACCEPT

it is not in docker

Grzesb · November 10, 2023 at 10:18 AM

Code

I think this is a problem with the interface connection itself.
After all, VNC using the zerotier IP address 192.168.194.53 should work immediately after connecting to the VPN network.
And VNC to the address 192.168.194.53 connects, the Kodi screen appears very slowly, I can click maybe once or maybe twice and it hangs. Reconnecting will also work the same.

Grzesb · November 15, 2023 at 7:38 AM

Ok I know why, all because of HDMI not connected.

I have dobę some code at autostart.sh and in config.txt.

But I do not know how to do it on other way.

I want run LE without any HDMI.

But when cat /sys/class/amhdmitx/amhdmitx0/disp_cap > /storage/.kodi/userdata/disp_cap

Vnc is running Blackscreen.

Grzesb · November 15, 2023 at 9:36 AM

I have read only system https://libreelec.dtech.hu/images/S8X2/

**dtech** · November 29, 2023 at 2:04 PM

Quote from Grzesb

I want run LE without any HDMI.
But when cat /sys/class/amhdmitx/amhdmitx0/disp_cap > /storage/.kodi/userdata/disp_cap

If the HDMI is not plugged in, the source is also empty, so you will create an empty file without any contained resolution.

Instead of this method, try to add a resolution statically, like this:

echo 1080p60hz > /storage/.kodi/userdata/disp_cap

It is also more than enough for simple VNC remote connection.

Grzesb · December 4, 2023 at 6:35 AM

After this I can connect with VNC but nothing can do.