DVB drivers for TBS Raspberry PI 4

Jarda · August 12, 2019 at 6:15 PM

Hello,

I run Libreelec 9.0.x with TBS 5927 (DVB drivers for TBS enabled) on Raspberry PI 3. I upgraded Raspberry PI from 3 to 4 version and Libreelec to 9.2 . The Tvheadened server can see TBS , but it can not scan the card.

Can you please help me with the problem with TBS driver ?

Thank you in advance.

Jarda

Code

2019-08-12 18:37:13.144 subscription: 0008: "scan" subscribing to mux "10747H", weig*t: 6, adapter: "STV091x Multistandard #1 : DVB-S #0", network: "Thor 0.8W", service: "Raw PID Subscription"

Code

2019-08-12 18:37:13.150 htsp: 192.168.0.20 [  | Kodi Media Center ]: Write error -- Broken pipe

Code

2019-08-12 18:37:13.155 htsp: 192.168.0.20 [  | Kodi Media Center ]: Disconnected

**CvH** · August 13, 2019 at 12:02 PM Official Post

pls share the output (an url with the log) of

dmesg | paste

Jarda · August 13, 2019 at 5:16 PM

Psl see atachment

kodi_log.txt

dmesg.txt

**CvH** · August 14, 2019 at 11:13 AM Official Post

from log I would guess you didn't used the driver-changer addon ?

instead you manually activated the driver addons ?

pls use the driver-chooser addon to select the drivers

Jarda · August 14, 2019 at 7:06 PM

I changed skin from the Confluence(you cann't find driver-changer in the skin) to the Estouchy and than I activated TBS driver for TBS from driver-chooser. I can say, that the behavior of TVheadend is the same as before the change - it can not scan the TBS card and TV headend do not respond when the TBS card driver is activated or card is pluged to Raspberry.

I attached the logs.

kodi_log.txt

dmesg.txt

**CvH** · August 14, 2019 at 7:46 PM Official Post

hmm this looks better

but could you unplug your dvb device, then reboot the RPi, wait a bit after reboot (~1min) then plug the usb device in

afterwards pls send a dmesg again (kodi.log is not needed)

Jarda · August 15, 2019 at 5:42 PM

I did it. The log file is dmesg.txt dmesg.txt

After 2 minutes I run scan in Tvheadend - the log file is dmesg1.txt dmesg1.txt

The problem, I guess, is in this row:

usb 1-1.1: DVB: adapter 1 frontend 0 frequency 0 out of range (950000..2150000)

Than I switched off the USB card and the log is dmesg2.txt

Jarda · August 19, 2019 at 6:03 PM

Than I switched off the USB card and the log is forum.libreelec.tv/core/attachment/5451/

Jarda · August 24, 2019 at 5:32 AM

Hello,

have you had any chance to continue in investigation ?