Redbear IOT pHAT Bluetooth support for Raspberry Pi Zero

I have one of these Redbear pHATs that provide WiFi and Bluetooth to the Pi Zero. LibreELEC supports the WIFI aspect of the board very well but unfortunately the Bluetooth is not detect. It is detected in a standard Raspbian install. The requirements are:

Quote

The IoT pHAT requires SDIO and UART as the interfaces to the host MCU. For Bluetooth, you also need to enable Bluetooth HCI UART protocol H4 driver as module.

Running `hciconfig` on Jessie Lite returns:

hci0:    Type: BR/EDR  Bus: UART
    BD Address: E0:76:D0:DD:E8:77  ACL MTU: 1021:8  SCO MTU: 64:1
    UP RUNNING
    RX bytes:717 acl:0 sco:0 events:42 errors:0
    TX bytes:1532 acl:0 sco:0 commands:42 errors:0

and lsmod returns:

Module                  Size  Used by
bnep                   11853  2
hci_uart               21122  1
btbcm                   7885  1 hci_uart
bluetooth             365780  22 bnep,btbcm,hci_uart
sg                     20799  0
ax88179_178a           16089  0
brcmfmac              202038  0
brcmutil                9031  1 brcmfmac
snd_bcm2835            23163  0
snd_pcm                95441  1 snd_bcm2835
snd_timer              22396  1 snd_pcm
cfg80211              499234  1 brcmfmac
rfkill                 21397  4 cfg80211,bluetooth
snd                    68368  3 snd_bcm2835,snd_timer,snd_pcm
bcm2835_gpiomem         3823  0
bcm2835_wdt             4133  0
uio_pdrv_genirq         3718  0
uio                    10230  1 uio_pdrv_genirq
ipv6                  367607  26

Any ideas what might be missing on LibreElEC and how we go about it getting it added. I believe that it is the same Bluetooth chip as the Rpi 3.

Thanks

The WiFi stopped working over night too on LibreELEC so I need to get to the bottom of that now too. It was working very well to begin with :s

Will post some logs later if they reveal anything useful.

WiFi seems intermittent still and the Bluetooth has yet to work. Grabbed some logs from a boot where the WiFi worked: ccjN

The chips used on this board are the same as those found in the Pi3 so I would expect them to work if all is well on the RPi3.

Tried the alpha (LibreELEC (Krypton) v7.90.007) and it is demonstrating the same issues.