New install, problems with first start

1st Official Post

    Hi,

    i had LibreElec running for some month. Then something went wrong with the SD-card, and it was not running fully anymore.

    So i reinstalled the complete software and imported the kodi database afterwards.

    Everything is running OK, but i have a problem when powering my media-devices.

    I have a Telefunken TV, and with the old installation, the Raspberry Pi was started, there was no need to start it with the HDMI enabled on the TV, it could start with the TV switched off, and later i could switch on the TV, navigate to the HDMI, and could see my Kodi.

    Now, i need to start the Pi with the TV on and with the HDMI enabled, otherwise there is no display. I need to restart the pi each time by unpowering and repowering it.

    Any solution for this? What can i change with settings to be able to start the Pi without a connected TV?

    Thanks a lot.

    • Official Post
    Quote from Minihawk

    What can i change with settings to be able to start the Pi without a connected TV?

    Try adding this to the config.txt file:


    #Always force HDMI output and enable HDMI sound

    hdmi_force_hotplug=1

    hdmi_drive=2


    Otherwise, do a fresh install of LibreELEC onto your SD card in case of possible sd corruption.